Sensor operation table Diag- nostic Item. Oil level warning light 51. Impeller shaft tilt limit 0. This information applies to vehicles already in service as well as to new vehicles that are being prepared for sale. Cylinder- 3 primary injector coupler Disconnect.
Turn signal relay lead 8. Always insert the probes from the opposite end of the coupler, taking care not to loosen or damage the leads. Headlight lead low beam 3. Brake pad clip Brake pad pin Brake pad spring Front brake pad Brake caliper piston Brake caliper piston seal Brake caliper piston dust seal Bleed screw For assembly, reverse the disassembly pro-. Fuel tank side cover Except for california Fuel tank breather hose Disconnect. Main and ignition Replace the fuse s.
Throttle position sensor for throttle cable pulley signal Diagnostic code No. All repair procedures are covered. Battery band Battery For installation, reverse the removal proce- dure. Air induction system cover Air induction system solenoid coupler Disconnect. Apply compressed air to the rear of the radiator. First edition, October 2007 All rights reserved. Clutch cable cle as shown in the illustration and insert it 3.
Left radiator fan motor lead a plastic locking tie, making sure the left 4. Symptom Defective throttle servo motor. Coolant reservoir breather hose main harness toward the back of the vehi- 2. Print what you need when you need it! Remove the connecting rod and big end bearings. Check the engine stop switch.
Measure the throttle position sensor volt- age. Intake funnel servo motor 1. Throttle position sensor for throttle cable. Open circuit is detected in the neutral switch. Atmospheric pressure sensor coupler Disconnect. Green Clutch Clutch type Wet, multiple-disc Clutch release method Outer pull, rack and pinion pull Clutch lever free play 10.
License plate light lead 11. Install the under spring seat. Water pump inlet hose 11. Symptom Open circuit detected in a primary injector. If this function detects a malfunction in the system, it immediately operates the engine under substitute characteristics and illuminates the engine trouble warning light to alert the rider that a malfunction has occurred in the system.
Cylinder- 3 ignition coil 27. After the check and service of the malfunctioning part has been completed, reset the meter display according to the reinstatement method. Route the sub-wire harness secondary injector through the area shown in the illustration. Cylinder- 4 ignition coil 40. Throttle cable free play 3. Hose clamp into the right coupler holder. Measure the brake disc deflection.
To secure the valve cotters onto the valve stem, lightly tap the valve tip with a soft- face hammer. Stand the vehicle on a level surface. Oil cooler outlet hose 7. Intake air temperature sensor 2. Bend the lead on the side of the fan motor 1. Throttle position sensor for throttle valves signal 1 Diagnostic code No.