This quick reference guide will assist you in locating a desired topic or procedure. Do not touch the spark plugs, ignition coils, or spark plug high-tension leads while the engine is running, or you could receive a severe electrical shock. Bypass Outlet Hose: Run the bypass outlet hose between the fuel tank and the straps as shown. Fix the throttle cable to the delivery pipe with the band. If it blown out, replace the fuse. If the speedometer does not work, check the speed sen- sor electric source voltage and speed sensor.
Possible causes Action Chapter Incorrect engine oil level Inspect see 4 chapter Engine oil poor quality or incorrect Change see 4 chapter Oil temperature sensor broken. If there is any doubt as to the condition of the reed, replace the air suction valve as an assembly. L: Apply a non-permanent locking agent. Storage of Removed Parts After all the parts including subassembly parts have been cleaned, store the parts in a clean area. Position the clamp pinch head below the horizontal plane.
Cooling and Bilge System Flushing. Genuine parts provided as spare parts are listed in the Parts Catalog. Air Suction Valve Hose 7. Main Relay in Relay Assembly 2. Cooling Hose Fitting Left Water Box Muffler 8. Maintenance Proper maintenance and repair are necessary to ensure that watercraft will continue to have low emission levels.
Main Relay in Relay assembly 2. Do not operate the watercraft with water in the engine. If any carbon accumulates, wipe the carbon off the throttle bore and throttle valve, using a cotton pad. Do not turn on the water until the engine is running and turn it off immediately when the engine stops. If necessary, replace it with a new one. Turning counterclockwise can cause water in the exhaust system to run into the engine, with pos- sible engine damage.
Air Suction Valve Hose Fitting 7. If clearance is between 0. Electrical System Battery Charging Condition Inspection Battery charging condition can be checked by measuring. Impeller Outside Diameter Standard: 147. Torque - Pump Mounting Bolts: 36 N·m 3.
Main Fuse 20 A 7. If the impeller is worn smaller than the service limit, re- place it. Boat smart from the start. Position the right rear duct under the right bilge hose as shown. Ignition Coil 2, 3 3. Install the clamp as shown, noting its screw head direction.
Harsh solvents may attack the surface or smear the colors. Any owner maintenance or repair procedure not performed in accordance with this manual may void the warranty. Position the clamp pinch heads as shown. Relay Assembly Circuit Inspection with the battery connected Battery Connection Tester Connection. Battery 12 V 18 Ah 7.
Pull on squeeze the straps and look for cracks. Please note: The linked sites are not under the control of Kawasaki and Kawasaki is not responsible for the contents of any linked site or any link contained in a linked site, or any changes or updates to such sites. Fuel Vent Check Valve Inspection. Start the engine by pressing the start button and run less than 15 seconds. Always follow safe operating and maintenance practices.