Ö 12-5 Remove the rear carrier. Couplers must be connected to other couplers of the same color. Rubber Cover Throttle Valve Disconnect the throttle cable from the throttle valve. Engine Ö Section 5 Driven pulley Ö Section 9 Carburetor Ö. Be careful not to damage the steering stem and front fork. Ö 12-4 Remove the rubber cover.
The problem is that once you have gotten your nifty new product, the kymco dink 50 service manual gets a brief glance, maybe a once over, but it often tends to get discarded or lost with the original packaging. Remove the frame body cover. Mongoose 70 2007 — 2017 Mongoose 70 First Gen. Ö 12-4 Remove the frame body cover. Check for dirty or clogged fuel filter and replace with a new one if it is clogged. Remove the handlebar upper cover. Remove the two bolts attaching the brake caliper.
Remove the cooling air tube band on the left crankcase cover and disconnect the cooling air tube. Drive a new bottom cone race into place with a proper driver. Drive Shaft Install the final gear and final shaft into the left crankcase. Do not turn the starter motor for a long time. The bearings must be replaced if they are noisy or have excessive play. Disconnect the instrument wire couplers and connectors. Protect wires and harnesses with electrical tape or tube if they contact a sharp edge or corner.
Ö 14-3 Inspect the rear brake drum. If you have trouble opening the manual please do not hesitate to contact us. Rear brake lining thickness 235. Ö 12-3 Disconnect the horn wire couplers. You will automatically be sent an e-mail to inform you when someone has reacted to your question. Measure the brake master cylinder piston O. Register a Free 1 month Trial Account.
Items Related for Removal x Handlebar front cover Headlight wire x Front cover. Remove the reed valve cover three bolts. Ö 12-5 Remove the met-in box. Do not remove the electrolyte cap. Check the float valve seat for wear or damage. Engine Oil : Apply grease for lubrication. Measure the clutch lining thickness.
Register a Free 1 month Trial Account. Do not damage the fuel unit wire. Check each weight roller for wear or damage. Please make sure that you describe your difficulty with the Kymco Grand Dink 50 as precisely as you can. Remove the final shaft oil seal. Remove the rear axle nut to remove the rear wheel. Resin Washer Countershaft Install the transmission case cover.
Tighten the 28mm nut to the specified torque. Stator Pulser Coil Remove the two pulser coil bolts and pulser coil from the right crankcase. Remove the reed valve and gasket. To open the manual you need any pdf reader. Drive in the left bearing. Do not squeeze wires against the weld or its clamp. Crankcase Assembly Tool Assemble the crankcase halves.
Mongoose 50 2T - Two Stroke First Gen. Tighten the lower mount bolts. Register a Free 1 month Trial Account. Remove the front upper cover. Be sure to align the punch mark with the holder joint.